nheuer Posted November 16, 2005 Share Posted November 16, 2005 Hello I am thinking about the new JBJ Picotope and making a custom top out of glass for it. One question I do have is can the light still be effective shining thru the glass or does it need to be open where the light shines. Also does anyone know when these will be out so I can see a better picture of one. Thanks NHEUER Link to comment
mickey85 Posted November 16, 2005 Share Posted November 16, 2005 You can put glass, plastic, plexiglass, etc on your tank to block the water from the light. Just make sure, if you use a light that gets very hot, to leave proper space between that and the plastic or plexiglass or it could melt. With glass, you wouldn't have that problem, but you would have problems with heat. Link to comment
nheuer Posted November 16, 2005 Author Share Posted November 16, 2005 Thanks for the info. The JBJ PICOTOPE has a raised light with remote ballast so I do not think their will beissues with the heat. Also it is only a 9w 50/50 lamp. Do you think that will have anyproblems going thru the glass? Check It out here http://www.jbjlighting.com/sys_pico.html Thanks NHEUER Link to comment
doncb Posted November 18, 2005 Share Posted November 18, 2005 Thanks for the info. The JBJ PICOTOPE has a raised light with remote ballast so I do not think their will beissues with the heat. Also it is only a 9w 50/50 lamp. Do you think that will have anyproblems going thru the glass?Check It out here http://www.jbjlighting.com/sys_pico.html Thanks NHEUER I don't think 9w is enough for anything. Also, note that they don't say Actinic. They call it "blue". I'd get a better light. At least 18w. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.