eight2178 Posted July 13, 2005 Share Posted July 13, 2005 when installing your hydor flows onto the output, how did you remove the little output spout thing thats there? file? dremel? hacksaw?...chainsaw!!? Link to comment
aleiodubua Posted July 13, 2005 Share Posted July 13, 2005 I just pulled mine right off...it came off so easily, I was curious as to how it even stayed on that long. Link to comment
eight2178 Posted July 13, 2005 Author Share Posted July 13, 2005 hmmmm....maybe im thinking too hard...ill try later...thanks. Link to comment
doncb Posted July 13, 2005 Share Posted July 13, 2005 Yep, the outlet pulls right off. Might have to give it a slight twist. The Hydor adapter that fits will fit inside the outlet. On my Hydor I cut off the collar on the back. The plastic is soft and I just scribed around the collar with the back side of the tip of a pointed x-acto knife. Came off clean. Link to comment
elimmel Posted July 14, 2005 Share Posted July 14, 2005 may i know which part of the hydor flo you guys are talking about? i just used some rubber tubes to fit the stock flo to the outlet of the 24G DX as it does not fit nicely. thanks Link to comment
burtbollinger Posted July 14, 2005 Share Posted July 14, 2005 mine fit fine forever, then about a week ago it started popping off. I used some electrical tape to thicken the valve a tad....so far so good. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.