Nocturnal Posted May 27, 2018 Share Posted May 27, 2018 I have a makers LED that I've just added some new red LEDs to (for a fuge). Added a new driver for the new LEDs but after power up the old LEDs are not firing and neither is the fan. Is it likely that I just burnt out the makers 2up driver/board itself? I have a couple plain menawell drivers on order so I hope that's what it is. I'm not sure what I could have done to fry the old circuit but leave the new one working fine. Quote Link to comment
jamescstein Posted May 27, 2018 Share Posted May 27, 2018 Check all the connections on the old circuit? Perhaps you just knocked a connection loose. Quote Link to comment
Nocturnal Posted May 27, 2018 Author Share Posted May 27, 2018 28 minutes ago, jamescstein said: Check all the connections on the old circuit? Perhaps you just knocked a connection loose. Yeah, that's what I'm trying now. I took a quick look earlier and it seemed ok. Quote Link to comment
Nocturnal Posted May 27, 2018 Author Share Posted May 27, 2018 I wired the drivers directly to the LEDs and the board is definitely toast. My fan seems gone too which is odd. Ok, more Frankenstein work. 🙂 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.