Connecting MakersDRIVER to Apex

[IAShane]

Hi, the MakersDRIVERs are listed as Apex ready, but I see no cable to do so on the website. I have the Apex VDM module, and the channels have Cat5 ports... So do I have to cut a Cat5 and wire it to the board? I've googled but have not seen any details on how to do this.

 

I have run the MakersDRIVERs with the Makers controller for a couple of years, but would like to have the two channels run independently.

 

Any help would be appreciated. Thanks!

[jedimasterben]

Yes, you will need to clip an ethernet cable and connect the correct wires.

 

Unfortunately, the MakersDriver works as a single unit when connected via 0-10v, so you will use the potentiometers to adjust for the color ratio you prefer and then use the 0-10v port to dim up and down according to the set maximum.