DC5 Posted May 28, 2014 Share Posted May 28, 2014 Allow my stupidity to be your resource! I will be ditching these drivers for LDDs at some point, but I want to try this controller out! I am currently running analog pots, and I know that I have to switch off PWM mode within the channel settings (which I did), but before I even touch the wiring, I want to be sure I do not do something incredibly stupid. Using a single channel as an example, can someone verify if I am about to do this correctly? The 9v adapter in my current setup is wired to a connector and then to the pot, but my illustration simply adds it to the flow so you know it is involved. Link to comment
DC5 Posted May 28, 2014 Author Share Posted May 28, 2014 I see your alarm went off Thanks, off to burn down the house! Link to comment
DC5 Posted May 28, 2014 Author Share Posted May 28, 2014 I LIVED! Still have to add the white channel and clean up the wiring, but so far so good. Thanks! Link to comment
DC5 Posted May 28, 2014 Author Share Posted May 28, 2014 for now Well, seeing as I just finished compiling the shopping list for my new LED's, drivers, and all that I need to maximize the controller... There is a chance my wife will kill me. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.