Boost led typhon controller

[Babgrip]

I have Red Sea Max 34 gallon reef tank .Recently converted lighting to led, Set-up consist of 36 Bridgelux 3watt LEDs 50/50 mix 3 Meanwell ELN-60-48P Drivers , Boost Led Typhon controller. I adjusted tho output of the drivers to the recommended output of 700ma set the desired parameters on controller. Upon start up the controller seems to work properly ramps up and down properly ,once the display reads zero across the board the LEDs are still burning I do not know at what percent as display reads zero my guess would be around 20% as the do not come on untill drivers reach 10% has anyone had this problem or know of any possible solutions thanks

[jedimasterben]

I have Red Sea Max 34 gallon reef tank .Recently converted lighting to led, Set-up consist of 36 Bridgelux 3watt LEDs 50/50 mix 3 Meanwell ELN-60-48P Drivers , Boost Led Typhon controller. I adjusted tho output of the drivers to the recommended output of 700ma set the desired parameters on controller. Upon start up the controller seems to work properly ramps up and down properly ,once the display reads zero across the board the LEDs are still burning I do not know at what percent as display reads zero my guess would be around 20% as the do not come on untill drivers reach 10% has anyone had this problem or know of any possible solutions thanks

The Meanwell P drivers won't turn on until they reach around 15% or so, and when it gets the signal that is lower than that the driver should shut off. Are the PWM ports wired correctly?

[Babgrip]

The Meanwell P drivers won't turn on until they reach around 15% or so, and when it gets the signal that is lower than that the driver should shut off. Are the PWM ports wired correctly?

i am using the 10v pwm ports negative on top positive bottom channels 1&3 are staying on channel 2 working properly

[Babgrip]

i am using the 10v pwm ports negative on top positive bottom channels 1&3 are staying on channel 2 working properly