Grendel0501 Posted January 9, 2009 Share Posted January 9, 2009 Visitherm heater , the suction cups don't come connected to the clips that hold them to the heater. The instructions don't say much about it just "attach suction cups". I tried jamming it on there , didn't work so well. I imagine I could get some needle nose plies and pull it through , but before I went the destructive route I wanted to ask what's the right way to do it? I have a feeling it is something real simple. Link to comment
BLoCkCliMbeR Posted January 9, 2009 Share Posted January 9, 2009 brute force........ mabe twist a lil too...... Link to comment
reefone Posted January 9, 2009 Share Posted January 9, 2009 just like ur gf. push it in Link to comment
Grendel0501 Posted January 9, 2009 Author Share Posted January 9, 2009 just like ur gf. push it in Just like with the gf , that doesn't seem to be working. Link to comment
HecticDialectics Posted January 9, 2009 Share Posted January 9, 2009 I tried jamming it on there , didn't work so well. ur doin it wrong consistent, firm pressure, then just slowly work it back and forth... Just like with the gf , that doesn't seem to be working. ^^ see above :X Link to comment
reefone Posted January 9, 2009 Share Posted January 9, 2009 try this should work for both. Link to comment
Grendel0501 Posted January 9, 2009 Author Share Posted January 9, 2009 You have to get it wet first. Noobs. I can't beleive my topic has gone this direction , I think my choices are to follow it , or be eaten by it. Link to comment
Grendel0501 Posted January 9, 2009 Author Share Posted January 9, 2009 As usual the gf was the one who got it in there. Not me. (seriously) I handed it to her , showed her the thread , she giggled and handed me back a suction cup attached to clip , in about 5 seconds. Link to comment
thecowkid Posted January 9, 2009 Share Posted January 9, 2009 musta been some cold water! Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.