ugination87 Posted February 13, 2006 Share Posted February 13, 2006 so after i drill my tank and put in the bulk head... am i supposed to glue it to the back?? Link to comment
shag26272 Posted February 13, 2006 Share Posted February 13, 2006 no, it has 2 parts , one for each side of the tank that screw together with a gasket in the middle. Link to comment
ugination87 Posted February 13, 2006 Author Share Posted February 13, 2006 the gastket is the rubber part right? do i glue the rubber to the back of thewall? Link to comment
kyle102565 Posted February 13, 2006 Share Posted February 13, 2006 you dont need to glue it, just make sure the gasket is between the inner glass and bulkhead flange. dont overtighten. Link to comment
ugination87 Posted February 13, 2006 Author Share Posted February 13, 2006 kk i was just about to glue the rubber onto the back when i saw this lolz Link to comment
shag26272 Posted February 13, 2006 Share Posted February 13, 2006 the rubber goes on the inside of the tank, on the piece that goes through the hole, dont put the rubber gasket on the side that you tighten. Just make sure the glass in clean, you dont need silicone or teflon or anything. Link to comment
reefman23 Posted February 13, 2006 Share Posted February 13, 2006 Hand tighten only... Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.