Ann Posted February 3, 2006 Share Posted February 3, 2006 Hey, I can't believe that I haven't commented in this tank before now. It's looking fantastic!! Don't keep it in hiding now, keep the updates and pictures coming. Best regards Ann Link to comment
DAP Posted February 7, 2006 Share Posted February 7, 2006 Excellent tank..... Are you still using the 18w light? How did you run the electrical cord for the heater into the fluval? Link to comment
BelowH2O Posted February 10, 2006 Author Share Posted February 10, 2006 Thanks DAP. Running the heater into the fluval filter is pretty simple. First I cut the powercord for the heater near a couple inches from the plug. Then I drilled a hole slightly smaller than the heater cord into the sponge compartment. After this thread the heater cord through the hole (should fit tight) and apply silicone on the inner and outer breech. Then I add a rubber guard over the cord and re-splice the wires. After the wire is connected I move the rubber guard over the raw wires, and wrap in electric tape. The light is still the same, 18w PC. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.