Eric_n_ga Posted March 16, 2019 Share Posted March 16, 2019 I have a kessil 160 and a series controller . All the programming works great . Where do the knob settings need to be while hooked to the controller ? All the way up ,down , if I turn the knobs it changes the light out put even when controller is hooked up ? So .... Quote Link to comment
A Little Blue Posted March 16, 2019 Share Posted March 16, 2019 24 minutes ago, Eric_n_ga said: I have a kessil 160 and a series controller . All the programming works great . Where do the knob settings need to be while hooked to the controller ? All the way up ,down , if I turn the knobs it changes the light out put even when controller is hooked up ? So .... It should not do that. Once the controller is connected, it should bypass manual fixture dial controllers. Make sure connection are correct and firmly pushed in, in the right port. Quote Link to comment
Eric_n_ga Posted March 16, 2019 Author Share Posted March 16, 2019 Does it need 2 cables or just the one. I'm running one now . From out put on controller to input on light . Quote Link to comment
A Little Blue Posted March 16, 2019 Share Posted March 16, 2019 Just now, Eric_n_ga said: Does it need 2 cables or just the one. I'm running one now . From out put on controller to input on light . Just one cable but there are two ports (on the fixture. Also check connection on controller OUT) One is the input from controller and the other one is a daisy chain output to another light if needed. Quote Link to comment
Eric_n_ga Posted March 16, 2019 Author Share Posted March 16, 2019 I turned it all off , cleaned the connections and it's functioning properly again . Weird part is the on off timer. Was still working ? Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.