Exodus Posted August 11, 2015 Share Posted August 11, 2015 Hey, So I got 2 BRS Dosing Pumps awhile ago and really haven't found a creative way of mounting these things as the back of the pump is just a flat surface, I received them used so its very possible I'm missing some sort of bracket. I have tried Scotch double sided adhesive padded squares I have used in the past for mounting rear surround speakers to stands, but even with 3 on the back the pumps fall off after a few days. What are others using for these pumps? Link to comment
HarryPotter Posted August 11, 2015 Share Posted August 11, 2015 Don't they have 3 spaces for screws? Why command strips- for noise reduction? Link to comment
Exodus Posted August 11, 2015 Author Share Posted August 11, 2015 Nope no holes for for screws(Hence why i wonder if there were brackets i wasn't sent). Command strips not only for noise reduction but they are also pretty strong from previous experience, They just aren't strong enough to hold the pumps, so before spending money on other solutions I wanted to see what others were doing. Link to comment
ps2cho Posted August 11, 2015 Share Posted August 11, 2015 Mine came with brackets thst I screw onto the wall. Then you slot the pumps into them. Make sure they aren't just attached and you haven't realized. Otherwise contact brs they may have just forgot to include them. Link to comment
Exodus Posted August 11, 2015 Author Share Posted August 11, 2015 Mine came with brackets thst I screw onto the wall. Then you slot the pumps into them. Make sure they aren't just attached and you haven't realized. Otherwise contact brs they may have just forgot to include them. Thank you! You nailed it, I took a good look at one of the pumps again and sure enough I saw they could be slotted brackets but I couldn't get them out, I remember trying when I first got them and was unsuccessful, so I got a hammer and a screw driver and that did the trick, they were wedged in there pretty good but luckily they slide in and out "A LOT" easier now. Link to comment
metrokat Posted August 11, 2015 Share Posted August 11, 2015 Hey, So I got 2 BRS Dosing Pumps awhile ago and really haven't found a creative way of mounting these things as the back of the pump is just a flat surface, I received them used so its very possible I'm missing some sort of bracket. I have tried Scotch double sided adhesive padded squares I have used in the past for mounting rear surround speakers to stands, but even with 3 on the back the pumps fall off after a few days. What are others using for these pumps? The back of the dosers should have an almost triangular shape to it, those are the brackets, they slide out and can be screw mounted o the wall, then the dosers slide down and snap into place. This picture (not mine) shows the bracket sitting in a zip lock Mine were too difficult to slide, i used some baby powder on the groves the help with the sliding and i also cut the little notch so they didn't "snap" into place Link to comment
wobar Posted August 12, 2015 Share Posted August 12, 2015 I mounted mine to the inside of my stand using the included bracket. I found it difficult to click in and out, so I just rest mine on the bracket, so it is easier to remove for maintenance. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.