Coastie Posted December 12, 2010 Share Posted December 12, 2010 So I bought a Tsunami ATO used off of a person on here a while back and am just getting around to using it. Well received the ATO and it appears it lost a fight with a heater. The unit that sits in the water had a hole in it which I don't suspect, if patched, will cause much of an issue. Anyhow I have since filled that hole with superglue and have tried using the thing again and it is constantly running. Any ideas as to how to get it to operate normally? Link to comment
JBM Posted December 12, 2010 Share Posted December 12, 2010 maybe that hole you filled in was supposed to be for the water level? remove the super glue & see if that fixes it Link to comment
Coastie Posted December 12, 2010 Author Share Posted December 12, 2010 Im pretty sure it's melted the mount is melted too. Link to comment
LPS-Crazy Posted December 12, 2010 Share Posted December 12, 2010 Does that use a float switch ? Is the float swich what is melted ? Link to comment
Coastie Posted December 12, 2010 Author Share Posted December 12, 2010 no its a tube... Its activated by suction. Link to comment
JBM Posted December 12, 2010 Share Posted December 12, 2010 Don't know what to tell you then Link to comment
Coastie Posted December 12, 2010 Author Share Posted December 12, 2010 Thanks though. I am just wondering if the switch went bad. May take it apart and see what's going on with it. Link to comment
JBM Posted December 12, 2010 Share Posted December 12, 2010 I'd imagine. If it stays running, a set of contacts are staying closed. That's not good. Try taking it apart & see where it takes you Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.