ATO Not Working

[swimmingswammi]

I bought this used and finally hooked it up. I have only one float switch. The float moves easily up and down. It is connected to the correct plug hole per the manual. I could not tell from the manual if the light for the switch should be on and what color. I tested the aqua lift to figure out which line is in and which is out. It works slow (drips and cannot pump more than a few inches high) but works. The power light comes on but the light for the float switch does not. Would this mean that I need to replace the float switch? Any feed back is greatly appreciated.

 

Craig

Alhambra, CA

[StevieT]

Light is green on the JBJ when power is on

 

Red lights only come on if the floats are switched. So if your tank float is low, red light comes on. If you reservoir is low and out of water, red light comes on.

 

Depending on your set up most run mode A

[swimmingswammi]

So what does it mean if the sensor light is off? what color light should i expect if the sensor is working and the sensor reads sufficient water.

[StevieT]

There will be no light on in the situation you describe.

 

If no sensor light is on then everything is good