bonsaidarrell Posted December 21, 2008 Share Posted December 21, 2008 OK, I'm trying to figure out the placement of my overflow, return and VorTech. I have a 17" cube that is going into a corner, so I have two backs (and two fronts). I'm thinking of putting my glass-holes overflow and return on one back panel, and the VorTech on the other. Any recommendations on how far below the surface the VorTech should be? And how far away from the side? Thanks, Darrell Link to comment
skydive Posted December 21, 2008 Share Posted December 21, 2008 2-3" below the surface and in the middle is where mine is. Also on the wet side there's the grate and then on that is a solid flat piece I think is an anti-vortex and you want that facing upwards so you don't pull in air from the surface. Link to comment
bonsaidarrell Posted December 21, 2008 Author Share Posted December 21, 2008 2-3" below the surface and in the middle is where mine is. Also on the wet side there's the grate and then on that is a solid flat piece I think is an anti-vortex and you want that facing upwards so you don't pull in air from the surface. Thanks! Do you run the spongy thing over it? -Darrell Link to comment
skydive Posted December 21, 2008 Share Posted December 21, 2008 Nope, it would probably be a good thing to use if it got rinsed regularly but I'm gone alot so it would just be getting clogged up. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.