Very simple MJ mod.....

[The Propagator]

This is the 1st tim eI have seen this mod so I appologize if its been posted Before.

If it hasnt.....Enjoy

 

 

I am positive this wil work with any power head too.

 

Very simple mod and it increases the width of the flow pattern.

[jamesnmandy]

yeah, there were a few threads here about this a year or so ago, i have three MJ600's in my tank with these mods, works well

[Hans Dorn]

Needs more sponsoring

[The Propagator]

HA HA !! that was funny wasn't it !

[coolwaters]

iv seen that before also did it to mine.

i didnt cut off the output tho since i need that for plumping...

the holes that i drilled didn't really help. i noticed that water was being shot out of them O.o

 

i like the stream mod....go 2000gph!!!

[The Propagator]

iv seen that before also did it to mine.

i didnt cut off the output tho since i need that for plumping...

the holes that i drilled didn't really help. i noticed that water was being shot out of them O.o

 

i like the stream mod....go 2000gph!!!

 

Probably because you either didnt enlarge the out put diameter to match the new intake volume ( IE cutting off the spout) or you drilled to large or to many holes?

[stoney waters]

It is very important that you do all cutting and drilling on your granite counter tops.

[Daemonfly]

It also depends on where you drill the holes. You want to drill them as close to the center as possible, as thats where the water will be drawn in. If it's too far out near the edges of the impeller, then water will come out the holes instead.