ToolboySA Posted October 18, 2016 Share Posted October 18, 2016 Hi I've just received my Bluefish Mini and so excited. Just need some clarification on the pin layout, before I nuke something I understand the left to right but is it 1 2 3 4 5 6 7 8 9 10 11 12 13 14 or 1 3 5 7 9 11 13 2 4 6 8 10 12 14 And lastly if powering via usb I dont use pin 1 & 2 right? thanks Link to comment
jedimasterben Posted October 18, 2016 Share Posted October 18, 2016 If powering by USB, do not use the leftmost pins. Top left pin is positive power, the next six pins are PWM output, and the entire bottom row is a common ground. Link to comment
ToolboySA Posted October 18, 2016 Author Share Posted October 18, 2016 Ahhh so layout is2. 4. 6. 8 10. 12. 141. 3. 5. 7. 9. 11. 13Thanks jedimasterben Link to comment
jedimasterben Posted October 18, 2016 Share Posted October 18, 2016 Not 100% sure on what those pins actually are numbered but in this photo you can see on the right-angle connector that the top row is VIN, then PWM 1, 2, 3, 4, 5, 6, can't see the bottom row but it's all ground Link to comment
ToolboySA Posted October 18, 2016 Author Share Posted October 18, 2016 I didn't even see the printing on the board I was just using the startup guide Thanks for clearing that up jedimasterben Link to comment
RollaJase Posted October 19, 2016 Share Posted October 19, 2016 I just went through this trying to check PWM signals for a channel with a multimeter. Basically the top row of pins are positive, the bottom row is negative. Power on the far left with channel 1-6 running from left to right. I think in the manual they number the pins from 1-14 going from left to right along the positive and then left to right along the negative. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.