Maui's Reef Posted October 4, 2016 Share Posted October 4, 2016 This was a request for a better frag plug for zoanthids. Ceramic was disliked because it was difficult to cut and often shattered. This plug is seven separate pieces connected by a small plastic connector. When ready to frag, cut the zoo colony with a blade, then just snap the individual pieces off. 3D printed using an FDM printer. Link to comment
NYfishies Posted October 4, 2016 Share Posted October 4, 2016 I like the idea, but you would need quite the large frag tank for that bad boy! Link to comment
Maui's Reef Posted October 4, 2016 Author Share Posted October 4, 2016 Oops, I guess I should have provided a sense of scale. Link to comment
NYfishies Posted October 5, 2016 Share Posted October 5, 2016 Ok there we go. Can you add the thing you have to hold it into the rack on just the center one? I'll try (buy) some. How can we make it happen? Link to comment
Maui's Reef Posted October 5, 2016 Author Share Posted October 5, 2016 Ok there we go. Can you add the thing you have to hold it into the rack on just the center one? I'll try (buy) some. How can we make it happen? Like this? PM me, I'd be happy to make some for you. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.