HM3105 Posted April 15, 2016 Share Posted April 15, 2016 Hey all, If I am running rebel es royal blues will I see any more "pop" in my corals by adding these ultramarine royal blues that Rapid is carrying? I Googled this a couple of times but did not find an answer. Sorry if I missed it and this has already been asked.. Link to comment
Matteo Posted April 15, 2016 Share Posted April 15, 2016 I am curious too on these. I didn't buy them though because I wasn't sure about them Link to comment
jedimasterben Posted April 15, 2016 Share Posted April 15, 2016 Depends on when you bought your rebels. If my driver setup wasn't limited in number of drivers, I would swap my Luxeon M for them. I much prefer the low wavelength royals. Link to comment
HM3105 Posted April 15, 2016 Author Share Posted April 15, 2016 Depends on when you bought your rebels. If my driver setup wasn't limited in number of drivers, I would swap my Luxeon M for them. I much prefer the low wavelength royals. Rebels were purchased 8 months ago (approximately). I got them from Steve's so I am not sure how old they actually are. I have M's running on my DT and I love them, this is for a frag swap light. Link to comment
jedimasterben Posted April 16, 2016 Share Posted April 16, 2016 If they were older Rebels from a few years ago they were the 440-445nm bin like these, but for the last couple years they've been the 450-455nm bin. Unfortunately they don't even make the Luxeon M less than 450nm or I would have some Link to comment
HM3105 Posted April 16, 2016 Author Share Posted April 16, 2016 If they were older Rebels from a few years ago they were the 440-445nm bin like these, but for the last couple years they've been the 450-455nm bin. Unfortunately they don't even make the Luxeon M less than 450nm or I would have some Cool, I may pickup a few of the UMRB then. Link to comment
jedimasterben Posted April 16, 2016 Share Posted April 16, 2016 I really wish these had more flux! I need at least 18x of them at 700mA to replace my six Luxeon M at 500mA, and I don't want to have to use another driver board to do it Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.