Jump to content
SaltCritters.com

Attempt at stand design for my new Fusion Lagoon 25!


Bryan47

Recommended Posts

So I just purchased the all in one nano tank from innovative marine; the Fusion Lagoon 25.

The stand that goes with it costs more than the actual tank so I decided to try and build something
simplistic that will function as a stand. The tank is 24 inches across and 20 inches deep so it is a pretty large footprint.
My idea was to make two squares using 2x12s and then I am going to use dowels and a sheet of plywood on top and on the bottom. Possibly on the sides as well. The center will likely stay hollow unless I decide to put some shelves up.
Any ideas or input would be greatly appreciated because I do not know much about would working!
The rendering I did is below:
Hope its easy to understand!
post-90795-0-67192900-1456961193_thumb.jpgpost-90795-0-23491700-1456961195_thumb.jpgpost-90795-0-87122700-1456961196_thumb.jpgpost-90795-0-34028000-1456961198_thumb.jpg
Link to comment

Archived

This topic is now archived and is closed to further replies.

  • Recommended Discussions

×
×
  • Create New...