Jorgieee Posted August 28, 2015 Share Posted August 28, 2015 Does anyone know how to take this pump apart? Link to comment
CAD-Aqua Posted August 28, 2015 Share Posted August 28, 2015 Hi, Jorgieee pump maintenance and disassemble: 1) unplug pump 2) wait for water from display drain into sump and make sure there is enough room in sump to hold extra water. wait until water has completely stop (if not enough room in sump, turn pump back on and remove some excess water). 3) now remove pump by unscrewing the outtake fitting of the pump until pump is removed 4) take pump to sink, remove front cap and wash 5) hold the center tabs of the pump cap, twist counter clockwise and give a gentle pull. this will expose the impeller. 6) gently pull the impeller shaft out, then impeller. clean out both as well as the impeller housing 7) clean outtake of the pump as well. 8) reverse steps to assemble and put back into the sump and turn on. Thanks Scott Link to comment
Jorgieee Posted August 30, 2015 Author Share Posted August 30, 2015 Thanks Scott I was able to figure it out ! hopefully it starts working good after that good cleaning I gave it. Hi, Jorgieee pump maintenance and disassemble: 1) unplug pump 2) wait for water from display drain into sump and make sure there is enough room in sump to hold extra water. wait until water has completely stop (if not enough room in sump, turn pump back on and remove some excess water). 3) now remove pump by unscrewing the outtake fitting of the pump until pump is removed 4) take pump to sink, remove front cap and wash 5) hold the center tabs of the pump cap, twist counter clockwise and give a gentle pull. this will expose the impeller. 6) gently pull the impeller shaft out, then impeller. clean out both as well as the impeller housing 7) clean outtake of the pump as well. 8) reverse steps to assemble and put back into the sump and turn on. Thanks Scott Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.