russ722 Posted January 5, 2015 Share Posted January 5, 2015 Finally started up my spec v today,everything seems fine, I did forget to plug up the hole on lower part of the wall. Hopefully someone can give me suggestions to close it up while filled? Also where should my water level be? Equipment upgrades: Mini jet 606 Koralia nano Surface skimmer Aqueon pro heater Future upgrades: Marine orbit led lighting Media basket Digital thermonitor ??? FTS 1-11-1 Link to comment
russ722 Posted January 7, 2015 Author Share Posted January 7, 2015 Updated pic and post.sorry for the crappy cell pics. Link to comment
Eckozulu Posted January 7, 2015 Share Posted January 7, 2015 I would just wait for the cycle to be done, then drain the water to below the hole and glue it shut. Put new water in and your tank is ready. For the water level, I kept it about 1/2 inch below the corner braces. If your touches them, you'll get crazy salt creep. Link to comment
russ722 Posted January 7, 2015 Author Share Posted January 7, 2015 Thanks eckzolu for the tip. As far as the water goes do you mean don't use the same water? Link to comment
russ722 Posted January 11, 2015 Author Share Posted January 11, 2015 Took some sand out and re worked the rock work best I could, any suggestions on scaping? The peice on the right I have about 1" clearance on the back side is that enough?. Also just ordered the mini jet 606, surface skimmer and a nano mag . Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.