dday80 Posted October 28, 2014 Share Posted October 28, 2014 Good Evening everyone, I have an old WM H1 skimmer. The impeller on my Sedra 2500 pump has swollen and cracked. I have tried to look around for a replacement, but it seems that they aren't manufactured anymore. Also, finding spare parts has been very difficult. Does anyone have any experience in changing the pump? Any advice would be greatly appreciated! Thank you. Link to comment
farkwar Posted October 28, 2014 Share Posted October 28, 2014 No experience with that skimmer. I would put a Sicce psk in it or a cheap Jebao dc pump with needke wheel in it. Cant be hard to swap it out. Link to comment
dday80 Posted October 29, 2014 Author Share Posted October 29, 2014 No experience with that skimmer. I would put a Sicce psk in it or a cheap Jebao dc pump with needke wheel in it. Cant be hard to swap it out. Thanks for your advice Farkwar. I assume I'll have to re-plumb based on the pump I decide to go with. Also, is it safe to assume that the pump I replace the 2500 with be comparable as to how many gph? Link to comment
farkwar Posted October 29, 2014 Share Posted October 29, 2014 Just get the lph of air and compare. Then get a little bigger. DC pumps have 6 speeds, so easier to calibrate I would think. Link to comment
Idontknowz Posted October 31, 2014 Share Posted October 31, 2014 the Warner marine H 1 skimmer is just the aquamaxx hob now. I think like farkwar said just uses the http://www.marinedepot.com/Sicce_USA-XJ-vd.html if I pasted that right Sicce Syncra 1.0 Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.