nicsound Posted February 23, 2015 Share Posted February 23, 2015 Cheers for the info. For the sake of a half inch you probably won't notice anyway, I think I'll make it the same as yours or even a smidgen wider depending on how much the bulkheads protrude. Thanks again. I'll post some pics when I get it done. Cheers for the info. For the sake of a half inch you probably won't notice anyway, I think I'll make it the same as yours or even a smidgen wider depending on how much the bulkheads protrude. Thanks again. I'll post some pics when I get it done. Link to comment
gulfsurfer101 Posted January 9, 2016 Share Posted January 9, 2016 Hell of a good job! I'm looking into following suit! Link to comment
cromag27 Posted January 9, 2016 Share Posted January 9, 2016 Hell of a good job! I'm looking into following suit! If you do, do NOT weld edges that have been flame polished! flame polishing can be done 24 hours AFTER all the joints have been welded together. Link to comment
gulfsurfer101 Posted January 9, 2016 Share Posted January 9, 2016 In all honesty I probably won't flame polish the edges. I was planning on having a detachable face plate where I can remove the teeth for cleanin and use ceramic magnets to hold it in place! Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.