sjnovakovich Posted March 15, 2014 Share Posted March 15, 2014 Worked out great. 80/20 t-slot aluminum Link to comment
bdevillier19 Posted March 16, 2014 Share Posted March 16, 2014 looks good. i plan on doing the same thing for my light. i'm also going to use a linear guide block with a hand brake on the back of my stand so i can adjust the height as needed, or raise it up for maintenance. Link to comment
sjnovakovich Posted March 18, 2014 Author Share Posted March 18, 2014 80/20 makes a bracket with a nylon bearing just for that purpose. A bit pricy though. I'm thinking about ordering one. Link to comment
bdevillier19 Posted March 18, 2014 Share Posted March 18, 2014 tell me about it. i'm looking at 150 or so just to hang my light Link to comment
sjnovakovich Posted March 18, 2014 Author Share Posted March 18, 2014 I spent just north of 120. The extrusions are cheap, but the connectors get pricey. Link to comment
RK_tek Posted March 26, 2014 Share Posted March 26, 2014 You can buy 80/20 scraps and connectors on that big auction site for quite a bit less than retail Link to comment
jedimasterben Posted March 27, 2014 Share Posted March 27, 2014 You gotta say, though, that extruded aluminum is sexy Link to comment
bdevillier19 Posted March 27, 2014 Share Posted March 27, 2014 and sexy is never cheap, but 80/20's ebay store does make it slightly cheaper. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.