Jump to content


Photo

Meanwell ELN driver inquiry


  • Please log in to reply
2 replies to this topic

#1
M@rine_lover

M@rine_lover

    Nano Reefer

  • Members
  • 180 posts
  • Joined 01 Dec 2007

Hi RapidLED,

I have 1 ProfiLux controller with 4 channel of 1~10V, 20mA output and I intend to use it to control 4x Meanwell ELN-60-48D.

Please advice what is the mA input needs at the dimmer pin of the meanwell driver?

#2
rapid LED

rapid LED

    Nano Reefer

  • Sponsor
  • 130 posts
  • Joined 11 Nov 2009
When we tested the dimming circuit it was drawing 3-4mA, but I believe MW advised it was between 5-10mA so you may not be able to run all 4 off the single output.

Hi RapidLED,

I have 1 ProfiLux controller with 4 channel of 1~10V, 20mA output and I intend to use it to control 4x Meanwell ELN-60-48D.

Please advice what is the mA input needs at the dimmer pin of the meanwell driver?



#3
M@rine_lover

M@rine_lover

    Nano Reefer

  • Members
  • 180 posts
  • Joined 01 Dec 2007

When we tested the dimming circuit it was drawing 3-4mA, but I believe MW advised it was between 5-10mA so you may not be able to run all 4 off the single output.


Since MW is 5~10mA, It seem pretty fine and safe for me to connect 2 MWs on single channel of the Profilux controller.

4 channels => 8 MW drivers => 96 LEDs.. :P !

Thanks.