Ok peps.

I am attempting to put 4x24w under a D-D 12g nano cube hood. I can get nanotuners stuff sent to me in the UK but the cost is very high so its a DIY job.

Ok I have two 12g hood now completly stripped down. I am looking at upgrading the standard fans to silenx pro 60mm 14cfm or 18cfm not sure yet both 60mm X 25mm. (think these will fit?)

Heat shield - well think I will just have to mod the existing reflector.

Problems - fitting it all in especially the starter units! think I will have to cut these down and attache them to the rear of the hood.

Any ideas, suggestions and recommendations.

Cheers,

Dan

anyone ? anyone at all?

you putting regular fluorescent tubes in there or power compacts?

Hey Dan,

Heres a link that should help you quite a bit.

I know that the nanotuners website also has a manual for the setup, it should help you understand everything.

http://www.nano-reef.com/forums/index.php?...mp;#entry738504

nanotuners(nanocustoms) has step by step youtube videos on installing lights