and now the 2 chamber off my solana is alot higher than the third.... is this normal and will it even out or should i add saltwater to compensate for the missing water in the third chamber

I had the same problem with my Aquapod, but with only two chambers. If you add more water to the third chamber, it will just empty out via the pump and raise your display level which will back up even more because of the Chemi-pure.

Think of it as a very annoying slow driver going up a very long hill - the only way to get around them is to take them out.

That being said, you could try flattening out the bag, or moving it to a different spot, but make sure that water passes through the bag or it won't be effective.

Good luck,

Brian

dangit alright well i will wait over night and hopefully it will go down in the second chamber

any one else with the solana had this problem

bump

Is this actually a problem? Is it just bugging you that the water level raised?

I had this same problem in my Cadlights 12. I solved it, mostly, by raising up the Chemi Pure bag by putting a few bio balls under it (just 4). Water level became much more consistent in the sump afterwards. I just rinse out the bio balls when I do my water change, to prevent problems.